GameCube Memory Card led modtutorial
Cool, hu?




Stuff you need:
1-4 led
The proper screwdriver (tri-wing for the official card)
Solder iron
Solder

Lets start by opening it up


***PIC***
Get the propper screwdriver and unswcrew the the screws.


Slide it

Whe you have unscrewed the screws pull/push like this.



Now you can do alot of stuff depending on your skill. But I'm gona describe two ways of putting in leds. You can either conect one led to one or one to both 3.3V or 2 leds to a 5V source. And if you want you can combinate the two to get tree or four leds in there. But ofcource if you know what you're doing you can do some paralell and stuff.

Now I'm gona show you where to get the energy.

V=volt

The pin I've marked with red gets 5V from the GC, the orange gets 3.3V and the black is the ground



When it comes to the leds, I suggest 3mm becous there is not mutch space in there. Often even a 3mm led has to be sanded down.

Not yet finnished, more to come...